![\"\"](\"https:\/\/einstein.amsterdam\/wp-content\/uploads\/dvmega.png\")
<\/p>\n<\/p>\n
With DVMEGA Dual Band Radio for ARDUINO, you can make a quick 10 mW hotspot which works on VHF or UHF.<\/p>\n
– Fits on Arduino UNO and MEGA 1280\/2560
\n– Dualband VHF\/UHF radio
\n– 10 mW output power
\n– SMA antenna connector
\n– Complete assembled<\/p>\n
http:\/\/www.dvmega.auria.nl\/<\/a><\/p>\n Instructions<\/p>\n Upgrade you DVMega<\/p>\n Step 1, Install USB driver for Arduino.<\/p>\n It is recommended to use for loading the firmware a standard Windows PC. Arduino website : http:\/\/arduino.cc\/en\/guide\/windows<\/a> Step 2, Load the firmware.<\/p>\n Download and install Xloader<\/a>. This is a simple program to load the firmware.<\/p>\n Download the hex file for your ARDUINO<\/a><\/p>\n Start Xloader, choose the correct hex file, select Device and set the COM port to the port number that is assigned to the ARDUINO. The baud rate defaults to 115200. Then press Upload to load the firmware. If the firmware is loaded correctly a message will appear below in the bar of the Xloader screen.<\/p>\n Finally Step 3 \ud83d\ude42<\/p>\n We have at least two options \ud83d\ude42<\/p>\n 1. BlueDV Software http:\/\/www.pa7lim.nl\/bluedv\/<\/a> Bluedv : MMDVMHost:
\nFirst you have to load the USB driver for the Arduino. Normally it will be recognized by Windows, in cases where it is not, I recommend to visit the following links:<\/p>\n
\nYoutube : http:\/\/www.youtube.com\/watch?v=-epgmDX9Zfw<\/a><\/p>\n
\n2. MMDVMHost Software https:\/\/github.com\/g4klx\/<\/a><\/p>\n
\nFollow my installation instructions for BlueDV here<\/a>.<\/p>\n
\nFollow my installation instructions for MMDVMHosthere<\/a>.<\/p>\n","protected":false},"excerpt":{"rendered":"